4 Digit Combination Barrel Sliding Bolt Latch W/ Anti-tamper Security Screws

Description

Vault Locks Set Your Own Combination Barrel Bolt With Anti-tamper One-Way Security Screws
A great flexible solution for sheds, barns, equipment, doors, gates, fences, or windows. The Vault combination barrel bolt offers an innovative security solution without hassle of keys. This combination locking bolt comes with pick-resistant dials, solid steel sliding bolt, and one-way security screws. The one-way screws are designed to turn only one way when using screwdriver. Sloped slot means a screwdriver will simply slip out if you try to turn it counter-clockwise. The Vault combination barrel bolt was designed with tight clearances to resist picking. Open the the bolt by entering your code and sliding the bolt. To lock the bolt, slide the bolt closed and spin dials to a random set of numbers. With a few simple steps, it’s easy to change combination. Whether you have a barn door or simple garden gate, the Vault combination barrel bolt is a simple and secure solution for everyone.
10,000 Re-settable different combinations
Anti-tamper security screws supplied
Corrosion resistant zinc die-cast body
Suitable for horizontal and vertical mounting
No keys to lose
NSTRUCTIONS:
To Open:
Rotate all 4 dials to the pre-set combination along the center line. The pre-set factory combination is 0-0-0-0
To Lock:
The combination must be scrambled by rotating the 4 dials. The slide bolt can be locked in the closed or open positions
Set Your Own Combination
On the end of the locking bolt, fully depress the small silver pin
While holding in the pin, rotate the 4 dials to your chosen combination (ensure that the numbers are aligned with the center line and have clicked into position)
Release the pin to the original position
Memorize and record the new combination for future use
Fitting Instructions:
Note: Regular screws can be used to temporarily measure hole alignments. You can then use the supplied one-way screws to complete the installation. It is important to drill a small pilot hole for the screws as they cannot be unscrewed once used.
Hold the slide bolt in the required position and check the slide bolt and the gate/door are positioned correctly
Mark the location of the 4 screw holes
The bolt should be mounted using all 4 corner fixing holes on the back plate
Drill a small pilot hole for the screws. Screws should be tightened without distorting the backplate
Maintenance
: It is recommended to rotate the dials on weekly basis to keep them moving freely